Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| en:clt:hotspot:software:cltdesigner:manual:modul_tbeam [2024/10/10 16:25] – [Cross section] Alexandra Thiel | en:clt:hotspot:software:cltdesigner:manual:modul_tbeam [2024/10/10 17:26] (current) – [Module "Ribbed slab"] Alexandra Thiel | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Module " | ====== Module " | ||
| - | {{ en: | + | {{ en: |
| ===== Input data ===== | ===== Input data ===== | ||
| Line 21: | Line 21: | ||
| In this release, only single span girder can be calculated. The supporting width and span (via x-value in the table) can be defined within this input field. | In this release, only single span girder can be calculated. The supporting width and span (via x-value in the table) can be defined within this input field. | ||
| - | {{ en: | + | {{ en: |
| ==== Cross section ==== | ==== Cross section ==== | ||
| Line 32: | Line 32: | ||
| The rib cross-section (rectangular cross-section made of glulam or solid wood) is defined by entering the height and width of the rib and selecting the material. If " | The rib cross-section (rectangular cross-section made of glulam or solid wood) is defined by entering the height and width of the rib and selecting the material. If " | ||
| - | {{ en: | + | {{ en: |
| ==== Loads ==== | ==== Loads ==== | ||